You can make a tiered skirt without a pattern, because every tier is a rectangle. Cut the rectangles from your measurements, sew each one into a loop, gather the top edge, and join the tiers. Then add a waistband casing and a hem.
What you need
- Your hip and waist measurements
- Your desired length, from the waist to the hem
- The width of your fabric, which is printed on the bolt label
- Elastic, usually 1 in (25 mm) wide
Step 1: Plan the tiers
- Top tier: for an elastic waist, make the top tier your hip measurement plus 5 to 10 cm (2 to 4 in). That lets it pull over the hips.
- Lower tiers: each lower tier is 1.5 to 2 times the width of the tier above it.
- Tier heights: equal heights, the total length divided by the number of tiers, or graduated heights with each lower tier taller. Three tiers is the classic layout.
- Seam allowance: add 1/2 to 5/8 in (1.2 to 1.5 cm) to every edge. Add hem and casing allowances separately.
As an example, a 38 in (96.5 cm) hip gives a top tier of about 42 in. Using 1.5 times for each step, the middle tier is about 63 in, and the bottom tier is about 95 in. Using 2 times instead gives 84 in and 168 in, which is much fuller and bulkier.
Step 2: Cut and sew the tubes
- Cut a rectangle for each tier. If a tier is wider than your fabric, join pieces along their short edges.
- Sew the short ends of each tier together, with right sides facing, to make open tubes.
- Finish the raw edges with a serger, a zigzag stitch, or French seams on sheer fabric.
Step 3: Gather each tier
- Sew two rows of long basting stitches, about 4 to 5 mm long, inside the seam allowance along the top edge of each lower tier.
- Pull the bobbin threads until the top of the tier matches the width of the tier above it.
You can also zigzag over a cord or dental floss, or use a gathering foot.
Step 4: Join the tiers
Divide each tier into quarters and mark them. Match the marks when you pin the gathered top of a lower tier to the bottom edge of the tier above. This keeps the gathers even. Sew with right sides facing, then remove the visible basting stitches.
Step 5: Make the waistband casing
- Elastic length: your waist measurement minus 5 to 10 cm (2 to 4 in). Don’t cut the elastic to the full waist measurement, or the skirt will be loose.
- Casing depth: the elastic width, plus about 1/4 in (6 mm), plus the seam allowance.
- Fold the top edge over to form a casing slightly wider than your elastic, leaving a small opening.
- Thread the elastic through with a safety pin. Overlap the ends and stitch them securely, then close the opening.
Step 6: Hem
Double-fold the bottom edge by 1/4 in (6 mm) and stitch it. A narrow rolled hem also works.
Fabric
Lightweight fabrics drape well when gathered. Good choices include cotton lawn, voile, rayon challis, chiffon, and light linen. Heavy fabrics get bulky at 2 times the width.
Common mistakes
- Cutting the elastic to the full waist measurement. The waist ends up loose.
- Gathering more than 2 times. The gathers get bulky.
- Assuming the tiers need equal widths. Each tier grows from the one above it.
- Thinking a waistband yoke is required. A self-casing works.
Where to go next
For a skirt with shaped fullness at the back, see how to sew a bustle skirt. For pattern sources, sizing, and other skirt shapes, see free and easy steampunk sewing patterns. The steampunk costume tutorial covers the rest of the outfit.