Costumes and Cosplay

How to Make a Steampunk Ray Gun Prop

Build a steampunk ray gun prop from a Nerf blaster or scratch-built parts, with copper coils, an LED glow, and metallic paint over plastic-bonding primer.

On this page
  1. Start with a base
  2. Scratch-build parts
  3. Wrap the coils
  4. Add a glowing chamber
  5. Prep the surface
  6. Paint
  7. Faux wood grips
  8. Glues
  9. Make it read as ray tech
  10. Rules and safety

A steampunk ray gun is mostly a toy with a few added parts that look like technology. Coils, glass, and dials make it read as “ray tech,” and an obvious fantasy look keeps it clearly a prop. Read the rules section before you take one to an event.

Start with a base

  • A Nerf blaster. The Nerf Maverick is a classic choice for steampunk mods.
  • A thrifted toy gun.
  • A scratch build from wood, PVC, and found parts.

Scratch-build parts

If you build from scratch, useful parts include PVC, wood, funnels, light bulbs, lamp parts, drawer pulls, faucet handles, ornaments, and test tubes.

Wrap the coils

Wrap 12 to 14 gauge copper wire around a dowel or around the barrel. Coils are a quick way to make a prop look more technical.

Add a glowing chamber

Put an LED behind a frosted test tube or a tinted-resin vial. Use a 3 mm or 5 mm LED, and add a resistor if the LED’s rating calls for one. A CR2032 (3 V) coin cell suits small builds. Secure the battery and insulate the wiring.

Prep the surface

Take the gun apart if you can. Sand the plastic with 220 to 400 grit sandpaper, then apply a plastic-bonding primer. Spray paint won’t hold on bare plastic. Wear a dust mask while sanding.

Paint

  1. Black base coat.
  2. Metallic coat in brass, copper, or silver.
  3. Dry-brushed highlights.
  4. Black or brown wash.
  5. A matte or satin clear coat.

Faux wood grips

For a wood-look grip, start with a tan base. Streak a darker brown on with a dry brush, then add a glaze. This looks more convincing than a plain brown paint.

Glues

  • Two-part epoxy: for structural joins
  • E6000: for decorative parts
  • CA glue: for small parts

Ventilate the room for epoxy, E6000, and spray paint.

Make it read as ray tech

Coils, glass, and dials read as technology. Gears alone do not make a ray gun. An obviously fantastical look keeps the prop clearly a toy, which matters for the rules below.

Rules and safety

  • Leave the blaze-orange tip on. US federal rules require the tip on commercially sold toy guns. Whether the wearer must keep it varies by law and venue, so check your event’s rules.
  • Many conventions inspect props at the door, and they may ask you to change a prop that looks too real.
  • Never modify a real firearm, an airsoft gun, or a BB gun to use as a prop.
  • Don’t carry a realistic-looking prop in public outside the event.
  • Ventilate for epoxy, E6000, and spray paint, and wear a dust mask when sanding.

For where props fit in the full outfit, see what steampunk accessories are. For the full build order, see the steampunk costume tutorial.

The complete guide to costumes and cosplay

Steampunk Costume Tutorial: Build a Cosplay Step by Step
Read the guide

Keep exploring

Guides from other topics

All topics →