DIY Crafts

How to Make Steampunk Medals

Make steampunk medals from a medallion, ribbon and pin back, using polymer clay, shrink plastic or resin, and invent your own honours for a fictional crew.

On this page
  1. What you need
  2. Choose the ribbon
  3. Fold the drape
  4. Make the medallion
  5. Attach the medallion
  6. Pin backs and rosettes
  7. Invent your own honours
  8. Common mistakes
  9. Safety

A steampunk medal is an invented honour: a medallion hung from a ribbon, with a pin back or a neck ribbon. Medals are quick to make, and the fun is in the made-up story behind them. Invent your own orders and symbols rather than copying real military decorations.

What you need

  • Ribbon, with grosgrain as a close craft substitute for military-style ribbon
  • A top bar or pin back
  • Jump rings
  • A medallion, such as a gear, coin, bezel, charm, button or bottle cap

Choose the ribbon

US military-style ribbon is 1 3/8 inches (35 mm) wide. A 1 1/2-inch grosgrain ribbon is a close craft substitute. Choose colours that suit the fictional order you’re inventing.

Fold the drape

Fold the ribbon into a point or a flat V about 2 to 3 inches long, then glue or stitch it at the top. A consistent fold makes the medal look more like a real decoration.

Make the medallion

Several materials work well:

  • Shrink plastic shrinks to roughly a third of its size and becomes much thicker. Bake it at about 325°F (163°C) for 1 to 3 minutes, and check the brand’s directions.
  • Polymer clay cures at about 110 to 130°C (230 to 275°F), typically 15 to 30 minutes per 1/4 inch of thickness. Times vary by brand.
  • Stamped clay takes an impression from gears, rubber stamps or buttons before it’s baked. Finish with Rub ’n Buff or a metallic wax.
  • UV resin in a bezel sets in minutes under a UV lamp.

Attach the medallion

Thread a jump ring through a hole or a bail on the medallion. To open a jump ring, twist it sideways with two pairs of pliers. Don’t pull it apart, because that warps the ring so it won’t close cleanly.

Pin backs and rosettes

  • Pin back: glue it to the back of the top bar with E6000 or epoxy, then let it cure for 24 hours before wearing.
  • Rosette: pleat the ribbon into a circle, then glue a cabochon or small gear in the centre.

Hot glue doesn’t hold pin backs on items that get worn, so use E6000 or epoxy instead.

Invent your own honours

Personalise your medals with fictional orders and themes, such as the “Royal Aether Corps,” airship crews or inventors’ guilds. Copying real military decorations, such as the Medal of Honor, is widely seen as disrespectful.

Common mistakes

  • Polymer clay doesn’t air dry. It must be baked.
  • Don’t bake polymer clay in food pans, and don’t exceed the brand’s temperature.
  • Hot glue won’t hold a pin back on something that gets worn.

Safety

  • Ventilate when you bake polymer clay or shrink plastic, and never exceed the brand’s temperature.
  • Wear nitrile gloves with uncured resin, and don’t look directly into a UV lamp.
  • Pin backs and small parts are choking hazards for young children.

For more on the accessories that go with a costume, see what are steampunk items. For the wider range of crafts, see the steampunk DIY crafts guide.

The complete guide to diy crafts

Steampunk DIY Crafts: Projects, Props and Gifts to Make
Read the guide

Keep exploring

Guides from other topics

All topics →