DIY Crafts

How to Make a Steampunk Computer and Keyboard

Steampunk keyboard and PC case mods: start with a mechanical keyboard, fit typewriter-style keycaps, add brass or wood trim, and keep case vents clear.

On this page
  1. Start with the right keyboard
  2. Use round typewriter-style keycaps
  3. Don’t chop keys from vintage typewriters
  4. Keep stabilised keys working
  5. Frame and trim
  6. Case ideas
  7. Clock and readout displays
  8. Safety

Steampunk keyboard mods have been around since roughly the late 2000s. Keys suit typewriter-style details well, so the keyboard is the most practical place to start. A full computer case is a bigger job, so this guide covers the keyboard first and then a few case ideas.

Start with the right keyboard

A mechanical keyboard with Cherry MX-style cross stems is the easiest base. You can pull the keycaps off with a keycap puller, and new caps snap on.

A membrane or laptop-style keyboard needs caps glued on, and it is harder to modify cleanly. If you’re new to modding, a mechanical keyboard is the better choice.

Use round typewriter-style keycaps

Round typewriter-style keycaps for MX stems are sold ready-made. They avoid gluing caps onto the switch, which keeps the keys working smoothly. Ready-made options include the Azio Retro Classic and the Qwerkywriter, a typewriter-style keyboard. Check the switch compatibility and layout before you buy.

Don’t chop keys from vintage typewriters

Pulling keys off a working vintage typewriter, sometimes called “key chopping,” is frowned on by collectors. Reproduction caps are the better choice, and they don’t damage a working machine.

Keep stabilised keys working

Stabilised keys, such as the spacebar, shift and enter, rely on stabilizer wires. Keep those wires free, or the keys can bind. Test every key with an online key tester before the final assembly, so you can fix any problem while the case is still open.

Frame and trim

Brass sheet, wood or leather can frame the keyboard. Prime plastic with a plastic primer, then add a metallic finish. Rub ’n Buff also works on small trim pieces.

For metal trim, use 3M VHB tape or epoxy. Hot glue lets go as the case warms up, so avoid it on anything that sits near heat.

Case ideas

PC case mods often use:

  • Brass or copper accents
  • Wood side panels
  • Gauge faces
  • Edison-style LED strips
  • Copper tube “plumbing”

Keep the intake and exhaust vents clear, and don’t cover the fan grilles. For a monitor, wrap or overlay only the bezel, and never cover the panel’s vents. Steampunk styling doesn’t change performance, so avoid anything that traps heat.

For the general look of these materials, see what materials are used in steampunk.

Clock and readout displays

Nixie tubes, used for clocks or readouts, need about 170 V DC from a dedicated driver board. Treat this as high-voltage work. Use an enclosed, insulated board, and skip the project if you’re new to electronics.

Safety

  • Unplug the PC and discharge static before you open the case.
  • Nixie supplies are high voltage, so use an enclosed, insulated board.
  • Cut brass sheet with snips and file the edges, since they are sharp.

For smaller tech builds, see how to make a steampunk phone case. For the full set of projects, see the steampunk DIY crafts guide.

The complete guide to diy crafts

Steampunk DIY Crafts: Projects, Props and Gifts to Make
Read the guide

Keep exploring

Guides from other topics

All topics →